First
Impressions The gun is supplied in a rather fancy looking silver
box held closed by latches and with a carrying handle on the top. Very
impressive looking! I unclipped the latches and opened the box. Inside were
the gun, 2 magazines, a bottle of BBs, a pair of safety glasses, a loading
rod and various leaflets along with the instruction booklet. Just looking at
the gun, and accessories, in the box, the whole thing looked very
presentable and great value.
I removed the gun from the box and began to inspect it more carefully. I
have to say that there is nothing about the gun that really strikes me as
being cheap and nasty. It just looks, well, like a normal airsoft gun. If
you’re used to full-metal AEGs then you might be disappointed by lack of
weight and the plastic finish but anybody who has only ever used a Tokyo
Marui gun will find nothing obviously sub-standard about it. People often
complain about the shiny black plastic receiver. I don’t see a problem with
this. Real L85 receivers were painted gloss black so the finish on the
Academy gun is actually quite realistic.
The only thing that obviously gives the L85 away as an airsoft gun is the
battery compartment built into the bottom of the fore-end. I’m not sure why
Academy didn’t design the gun so that the battery could be inserted via the
hatch in the top of the fore-end.
Overall, the gun feels sturdy. It doesn’t creak or rattle at all although
certain things begin to give away the cheap construction of the gun. The
flash-hider is plastic and is held in place with a rather large Philips
screw. The SUSAT is rather cheap looking and there are quite a few recessed
holes visible where self-tapping screws hold various parts of the gun
together. I also noticed that the front and rear sling loops are made of
plastic. It would be preferable if these were made of metal.
The gun has a safety-catch above the trigger which works independently of
the fire selector switch. The fire selector, which has safe, semi and
full-auto settings, can be found on the left-hand side of the gun at the
rear. Opposite the fire-selector, on the right-hand side of the gun, there
is a fake bolt-release lever. Above this there is a moveable, but
non-functional, charging handle which causes the ejection cover to spring
down when cycled. One clever feature of the gun is that the hop-up assembly
is molded from transparent plastic so, with the charging handle pulled back,
it is possible to check if a BB is loaded. This comes in handy because the
gun has a habit of holding a BB in the breech, even with the magazine
removed. The magazine release lever can be found on the left-hand side of
the receiver, above the mag-well. The mag-release lever stands a long way
proud of the receiver and is just as prone to causing accidentally dropped
magazines as the real gun. Finally, behind the mag-well, on the underside of
the receiver, there is a tiny lever which allows the user to decompress the
spring.
Of all the exterior parts, only the trigger, trigger guard,
trigger-safety and magazine release lever are made of metal.
I’m not sure I can properly express just how “normal” this gun looks. I
was expecting it to feel horribly cheap, poorly made, rather flimsy and with
obvious flaws. In fact it has none of these things. It is solid, accurately
constructed and the plastic is a reasonable quality, with only a few molding
marks visible.
Shooting Before shooting
the gun a battery must be fitted. There is a rather large black fastener
which must be turned to unlock the battery compartment. The instruction book
recommends the use of a 7.2v battery and I used one from an r/c car. A
normal 8.4v large battery would also fit although I couldn’t guarantee that
the Academy gearbox internals could withstand the extra load without damage.
There is a heavy duty rubber band inside the battery compartment and you
should slide the battery underneath this. Basically, this stops the weight
of the battery from resting on the battery cover which is rather flimsy. The
fuse, should you ever need access to it, can be found under the top hatch in
the fore-grip, which simply pulls open.
I took a magazine and the loading rod out of the box next. I filled the
loading rod with BBs and tried to push them into the magazine. This was when
I had my first clue as to how undeveloped airsoft was at the time when
Academy designed the L85. It seems that the loading tube is made out of
tubing which is about 10mm diameter. Rather than pressing down into the
magazine, the BBs simply form a zig-zag column inside the tube and jam
there. I would advise any new owners of this gun to throw away the Academy
loading tube straight away. It is infuriatingly useless.
After binning the loading rod I used my TM speed-loader and quickly had
30 BBs inserted in the magazine. I noticed, after loading the magazine, the
seams of the mag had started to come apart very slightly. It appears that
the mag is a simple sandwich construction and, when the spring is
compressed, it begins to push the two halves apart slightly. This isn’t a
big problem. It is simply another indication that the gun was designed in an
age when details were not as important as they are today. The magazine,
being plastic, fits with a rather dull click. It is, however, surprisingly
solid once in place.
With
the battery fitted and the magazine loaded, there is one final thing to do
before firing. The RDS must be powered up. The switch for this can be found
underneath the SUSAT on the right-hand side. The tiny switch is not very
robust or waterproof but operates with a positive click. With the SUSAT
illuminated, I shouldered the gun and aimed it at my usual 10 metre target.
Looking through the SUSAT it is easy to see that it is fairly poor quality.
The LED used is rather big and it projects a large, blurry, dot onto the
sight picture. Worse than this, however, Academy have chosen to build the
SUSAT in the same way in the same way that toy binoculars are often made.
Instead of magnifying the image through the scope, the lenses actually make
the image smaller. Very strange!
Peering through the SUSAT, my target looked like it was about 30m away
and the red dot appeared large enough to obscure the target entirely. I
aimed as best as I could and fired a few shots in semi-auto. Upon
inspection, most of the shots had hit the target but with no real grouping
or accuracy. For my next attempt I used the iron sights built into the top
of the SUSAT. The iron sights are truly tiny, however, and the sight picture
is very small. Another ten shots in semi-auto showed good grouping although
none were anywhere near the bullseye.
The gun has a fixed hop-up so the only solution is to adjust the SUSAT to
try to improve accuracy. Unfortunately, the construction of the SUSAT mount
is rather flimsy. The mount of the real SUSAT was always considered complex
but, due to accurate construction, works well. Unfortunately, the Academy
version is poorly constructed and the SUSAT wobbles rather alarmingly. If I
planned to use the replica SUSAT in standard form I would be tempted to glue
the joints of the mount, after zeroing the scope, to try to make the sight
more solid. All of the controls for the SUSAT are fake except for the large
elevation dial on the mount, which I adjusted to improve the accuracy. There
is no way to adjust for windage.
After adjusting the sights I switched the gun to full-auto and emptied
the magazine into the target. The rate of fire is surprisingly good and the
magazine was empty in a couple of seconds. It’s worth noting that the
magazine always empties faultlessly, which is more than sometimes can be
said for other, more expensive, guns.
In full-auto the gun actually managed better groups than in semi-auto. I
assume this is because the shots follow each other before I moved and
altered the point of aim.
I reloaded with a fresh magazine and emptied it into a new target. The
results were similar and, with subsequent magazines, I always found that far
tighter groups were achieved by emptying an entire magazine in full-auto
rather than using short bursts or single shots.
At this point it’s worth mentioning the balance of the gun. Being a
bullpup, the L85 has the gearbox fitted right at the rear of the receiver.
This means that the guns centre of gravity is well to the rear. This is most
apparent when changing the magazine. When I took my hand off the fore-grip
to remove the mag’, I actually found it quite hard to hold the gun level
with only my right hand holding the pistol grip. After a couple of hours use
the feeling subsides a bit but returns for the first few minutes every time
I use the gun. The gun is very comfortable to shoulder or to carry but can
be a little clumsy to pick up or handle in other ways.
Although the sights are rather poor I found that the gun almost always
hit a 6” square target at a range of 10 metres. I don’t think that there are
any real problems with the gun being inaccurate. It’s simply that the
standard sights aren’t capable of any great accuracy. The fixed hop-up seems
to produce a fairly flat trajectory with the 0.2g BBs that I was using. I
should note that the 0.12g BBs which were supplied with the gun were never
used although they seem to be decent quality.
Overall, accuracy is reasonable. The unstable mount is probably
responsible for most of the inaccurate shots. It’s possible to simply push
the SUSAT and cause it to move by at least 5mm. Also, because the iron
sights are mounted on top of the SUSAT, the iron sights are not much more
accurate than the scope.
Finally, I fired a few shots through my chronograph and found that 0.2g
BBs fired at a speed of around 165ft/sec. This equates to a power of around
0.3J. Not terribly powerful but surprisingly useful in practical terms. I’d
say this gun would manage a useful range of 25m without too many problems,
even with the standard sights.
Throughout my test-firing of the gun I was listening for any strange or
dubious sounds from the gearbox but heard nothing out of the ordinary. The
spring inside the gun is very weak, however, so I don’t imagine that the
standard gearbox is under much stress at all.
Once again, I found myself surprised by just how well the gun performed,
even if the sights are a little bit sub-standard.
Technical I bought the Academy L85
with the specific purpose of upgrading it into a first rate AEG. It’s
difficult to discuss the standard AEG without considering upgrades I either
have made or intend to make. There is no way to field-strip the gun so I had
to dismantle the gun into it’s components in order to upgrade the gearbox. I
was pleasantly surprised to see that the gearbox seems to be pretty
well-made. The metal is finished rather poorly and it is held together with
self-tapping screws (as well as a single anti-tamper rivet) but it seems to
be strong, accurately machined and comes with metal bushes. The gears seem
of decent quality although my usual test (scratching one with a scriber)
showed that they aren’t terribly hard. The piston, itself seems to be good
quality and the cylinder has no vents because the barrel is so long.
The barrel is incredibly long, at roughly 490mm. That’s 140mm longer than
the barrel of an M4, even though the gun is very slightly shorter. The
gearbox, hop-up, and barrel are all built into the left-hand side of the
gun. The front section of the barrel is shrouded in a plastic box-section
support. This isn’t very pretty but is functional, does a good job of
holding that long barrel securely and is hidden by the fore-grip when the
gun is assembled.
One problem with the internal mechanism, which required immediate repair,
was the trigger linkage. This is constructed in two sections which join with
a plastic sleeve. The plastic sleeve is rather weak and easily breaks. I
found that after a couple of hours of use it had already split along one
side. I repaired this by binding the sleeve with cotton and then dabbing
super-glue over the repair, basically the same procedure that a fisherman
uses to bind an eye to a new rod.
The gun, itself, seems reasonably accurate but is badly let down by the
sights. The optical SUSAT sight is functional but very toy-like and the iron
sights, since they’re mounted on top of the SUSAT, are also prone to
inaccuracy caused by the mounts being rather flimsy.
To be honest, sorting out the problems with the SUSAT will probably be
more challenging that upgrading the gun itself. At the very least, I would
suggest dismantling the sight unit, removing the lenses and rebuilding it
with clear, flat, polycarbonate in place of the lenses. Personally, I would
consider buying a cheap red-dot sight and fitting it inside the SUSAT shell
for a better sight picture. Even with those modifications, however, the
SUSAT mounts are terribly flimsy and not very good for accuracy. To be
honest, I suspect that I will fit a weaver rail to the receiver of my L85
and use it with a normal red-dot sight while I consider what I can do with
the SUSAT to improve its performance.
The final hurdle facing owners of the Academy L85 is the magazines. The
real SA80 fits STANAG magazines so the gun should take M16 magazines.
Unfortunately this isn’t the case. The designers of the Academy L85 must
have misjudged the dimensions slightly and the result is that the L85
magazines are slightly smaller than Armalite ones, meaning that M16
magazines are too large to fit the L85 without modification. It should be
possible, however, to enlarge the L85 mag-well slightly so that the M16
mag’s will fit. The mag-release slot is in the same place on L85 and M16
mag’s so, once the mag-well has been enlarged, standard M16 mag’s should fit
easily.
Alternatively, genuine L85 magazines are, apparently, available from
Hong-Kong suppliers. Personally, I’d rather modify the gun to suit M16
magazines so that I can share ammo with team-mates.
Conclusion
The Academy L85 could have been a very good AEG. As things stand
it’s more of a quirky alternative to more expensive guns.
At the risk of labouring the point, the gun is badly let down by the
sights. This is made worse because it’s not possible to remove the SUSAT and
replace it with another RDS without some modification to the gun, however
the gun, itself, is adequate as standard. You really could just buy this gun
and use it for skirmishing without any modification.
If you decide to upgrade the gun then it should be fairly straightforward
to fit TM gears and a suitable spring, spring-guide and hop-up and it would
be the equal of most guns currently available. Beyond that, the odd sized
magazines stop the gun from being truly practical. The owner is left with
the choice of either adapting the gun to suit standard M16 magazines or
attempting to buy a number of Academy mag’s.
As
standard the gun is probably better for skirmishing than it is for plinking.
The poor sights will soon begin to frustrate anybody using the gun for
plinking or target-practice. During a skirmish the poor sights are not so
much of an issue and the low power really isn’t a problem. Unfortunately, of
course, the poor availability of Academy magazines makes it harder to use
the gun for skirmishes.
The gun is definitely strong enough to stand up to the punishment of a
skirmish and it looks good too. Upgrade the Academy L85 with a few parts
from a TM FA-MAS and you’ll have a gun which will be the ultimate “sleeper”.
It would be very easy to create a stunning custom gun to be proud of by
using this gun as a base for the project. The only thing that lets the gun
down, and really deserves to be upgraded at the same time as the rest of the
gun, is the sights.
